Air Powered Instructions -
Instructions for the ALL-in-ONE VAK-Matic controller (2-4-6).
Congratulations, you have just purchased the finest system ever made for VAKuum Bag Veneering & VAKuum Klamping. This system combines the best features of
both applications into one complete system.
To run the system properly, you must make a few modifications when moving from one application to the other.
ON / OFF Valve at rear of box
Keep the valve handle perpendicular to the vacuum line when using the system for veneering (VAK-BAG). When used for VAK Klaming, turn the valve handle 90 degrees to open the valve. This will allow air to bleed back to your vacuum jig when you step on the bottom of the foot pedal to turn the air off.
ON/OFF SWITCH
Make sure that when you are clamping you have the red ON/OFF switch on “VAK-KLAMP.”
Never have the switch on “VAK-BAG” when you are clamping. Only use “VAK-BAG” when you are veneering.
KEEP THE AIR PRESSURE BELOW 100PSI While the unit is demanding compressed air OR YOU WILL DAMAGE THE SOLENOID.
74 Apsley Street Hudson, MA 01749
Phone: (978)562-4680
Fax: (978)562-4681
