Air Powered Instructions -

Instructions for the Industrial ALL-in-ONE VAK-Matic.

Congratulations, you have just purchased the finest system ever made for VAKuum Bag Veneering & VAKuum Klamping. This system combines the best features of both applications into one complete system.

To run the system properly, you must make a few modifications when moving from one application to the other.

ON / OFF Valve at rear of box

Keep the valve handle perpendicular to the vacuum line when using the system for veneering (VAK-BAG). When used for VAK Klaming, turn the valve handle 90 degrees to open the valve. This will allow air to bleed back to your vacuum jig when you step on the bottom of the foot pedal to turn the air off.

ON/OFF SWITCH

Make sure that when you are clamping you have the red ON/OFF switch on “VAK-KLAMP.” Never have the switch on “VAK-BAG” when you are clamping. Only use “VAK-BAG” when you are veneering.

TOGGLE SWITCH

When you are veneering, put the toggle switch to the ON position. This will make all venturi pumps in the system work together to evacuate the bag faster.

There are three venturi pumps inside your “VAK-MATIC” controller. When Klamping, you normally will not need all pumps working at the same time. Therefore, you can put the toggle switch to the OFF position when you are Klamping. This will reduce your compressed air usage, and make your system work more efficiently. When you turn the toggle switch to OFF, you must use the tee and short hose set up to combine the two vacuum lines intro one.

KEEP THE AIR PRESSURE BELOW 120PSI OR YOU WILL DAMAGE THE SOLENOID.